Main wall surfaces
Stucco, block, and siding are reviewed for chalking, fading, peeling, cracks, prior coatings, and access conditions.
Exterior painting · Clearwater, Florida
Florida sun, rain, humidity, and salt air place different demands on exterior coatings. The work starts by understanding the condition of your home and preparing every surface for a finish that looks right and lasts.
Defined scope
The estimate identifies the surfaces to be painted and the preparation appropriate to their visible condition. Products, colors, access, occupied areas, and exclusions are confirmed before the final scope is set.
Stucco, block, and siding are reviewed for chalking, fading, peeling, cracks, prior coatings, and access conditions.
Fascia, soffits, window and door trim, shutters, railings, and selected details can be measured as separate scope components.
Entry doors, garage doors, and architectural accents can be included without assuming a whole-home repaint.
Before the finish
Identify coating failure, moisture staining, loose material, failed caulk, rust, and other visible conditions.
Define surface cleaning or pressure washing where it supports the coating system and the approved scope.
Scraping, sanding, feathering, caulking, limited patches, and spot priming are described where needed.
Specify the surfaces, products, colors, sheen, coat assumptions, protection, and cleanup in writing.
Service area
Clearwater anchors the primary service area for exterior projects. Tarpon Springs is the northern limit; projects outside the highlighted area may still be considered based on scope and schedule.
Project details first
Share the location, surfaces, visible condition, preferred timing, and photos if you have them. The submitted details support an initial estimate; field conditions may change the final scope.
Start an estimate